The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot harder.
Getting a new swim spa is an amazing event in life. You’re looking forward to the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have lastly made a selection from the various models you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets home with your brand-new purchase will be a 4 section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence because as soon as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made of individual areas, at differing speeds. So eventually you’ll see one or two of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much aid due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually wind up in some land fill, they designed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to buy today, bookmark this website so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *