The Challenges to Swim Spa Covers

Swim Spas represent unique difficulties when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a new swim spa is an amazing event in life. You’re anticipating the workout you’ll obtain from using it. Perhaps you’re a little relieved to have lastly selected from the different designs you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Normally, the cover that gets home with your brand-new purchase will be a four area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence because as soon as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are very little as they increase from the water surface area.

They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It takes place slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So eventually you’ll see a couple of of the sections are actually getting heavy. The bar lifters on completions of the swim spa aren’t much assistance due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a various style for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually end up in some landfill, they created one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this website so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *