Getting The Best Swim Spa Cover

Swim Spas represent unique challenges when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a new swim spa is an amazing event in life. You’re looking forward to the workout you’ll receive from using it. Possibly you’re a little relieved to have actually finally made a selection from the various designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Typically, the cover that gets back with your brand-new purchase will be a 4 section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence since as soon as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are really small as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It takes place slowly and on a Swim Spa Cover which is made of specific areas, at differing speeds. So eventually you’ll observe one or two of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will ultimately end up in some landfill, they created one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not ready to purchase today, bookmark this website so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *